1 files changed, 18 insertions, 22 deletions
diff --git a/EmbeddedPkg/Drivers/Lan9118Dxe/Lan9118DxeUtil.c b/EmbeddedPkg/Drivers/Lan9118Dxe/Lan9118DxeUtil.c
index 3ef98ef901..bd20eebd04 100644
--- a/EmbeddedPkg/Drivers/Lan9118Dxe/Lan9118DxeUtil.c
+++ b/EmbeddedPkg/Drivers/Lan9118Dxe/Lan9118DxeUtil.c
@@ -236,7 +236,7 @@ IndirectEEPROMRead32 (
 
   // Write to Eeprom command register
   MmioWrite32 (LAN9118_E2P_CMD, EepromCmd);
-  MemoryFence();
+  gBS->Stall (LAN9118_STALL);
 
   // Wait until operation has completed
   while (MmioRead32 (LAN9118_E2P_CMD) & E2P_EPC_BUSY);
@@ -284,7 +284,7 @@ IndirectEEPROMWrite32 (
 
   // Write to Eeprom command register
   MmioWrite32 (LAN9118_E2P_CMD, EepromCmd);
-  MemoryFence();
+  gBS->Stall (LAN9118_STALL);
 
   // Wait until operation has completed
   while (MmioRead32 (LAN9118_E2P_CMD) & E2P_EPC_BUSY);
@@ -362,14 +362,13 @@ Lan9118Initialize (
   if (((MmioRead32 (LAN9118_PMT_CTRL) & MPTCTRL_PM_MODE_MASK) >> 12) != 0) {
     DEBUG ((DEBUG_NET, "Waking from reduced power state.\n"));
     MmioWrite32 (LAN9118_BYTE_TEST, 0xFFFFFFFF);
-    MemoryFence();
+    gBS->Stall (LAN9118_STALL);
   }
 
   // Check that device is active
   Retries = 20;
   while ((MmioRead32 (LAN9118_PMT_CTRL) & MPTCTRL_READY) == 0 && --Retries) {
     gBS->Stall (LAN9118_STALL);
-    MemoryFence();
   }
   if (!Retries) {
     return EFI_TIMEOUT;
@@ -379,7 +378,6 @@ Lan9118Initialize (
   Retries = 20;
   while ((MmioRead32 (LAN9118_E2P_CMD) & E2P_EPC_BUSY) && --Retries){
     gBS->Stall (LAN9118_STALL);
-    MemoryFence();
   }
   if (!Retries) {
     return EFI_TIMEOUT;
@@ -449,12 +447,11 @@ SoftReset (
 
   // Write the configuration
   MmioWrite32 (LAN9118_HW_CFG, HwConf);
-  MemoryFence();
+  gBS->Stall (LAN9118_STALL);
 
   // Wait for reset to complete
   while (MmioRead32 (LAN9118_HW_CFG) & HWCFG_SRST) {
 
-    MemoryFence();
     gBS->Stall (LAN9118_STALL);
     ResetTime += 1;
 
@@ -503,7 +500,7 @@ PhySoftReset (
 
     // Wait for completion
     while (MmioRead32 (LAN9118_PMT_CTRL) & MPTCTRL_PHY_RST) {
-      MemoryFence();
+      gBS->Stall (LAN9118_STALL);
     }
   // PHY Basic Control Register reset
   } else if (Flags & PHY_RESET_BCR) {
@@ -511,7 +508,7 @@ PhySoftReset (
 
     // Wait for completion
     while (IndirectPHYRead32 (PHY_INDEX_BASIC_CTRL) & PHYCR_RESET) {
-      MemoryFence();
+      gBS->Stall (LAN9118_STALL);
     }
   }
 
@@ -545,7 +542,7 @@ ConfigureHardware (
 
     // Write the configuration
     MmioWrite32 (LAN9118_GPIO_CFG, GpioConf);
-    MemoryFence();
+    gBS->Stall (LAN9118_STALL);
   }
 
   return EFI_SUCCESS;
@@ -588,7 +585,6 @@ AutoNegotiate (
     // Wait until it is up or until Time Out
     Retries = FixedPcdGet32 (PcdLan9118DefaultNegotiationTimeout) / LAN9118_STALL;
     while ((IndirectPHYRead32 (PHY_INDEX_BASIC_STATUS) & PHYSTS_LINK_STS) == 0) {
-      MemoryFence();
       gBS->Stall (LAN9118_STALL);
       Retries--;
       if (!Retries) {
@@ -675,7 +671,7 @@ StopTx (
     TxCfg = MmioRead32 (LAN9118_TX_CFG);
     TxCfg |= TXCFG_TXS_DUMP | TXCFG_TXD_DUMP;
     MmioWrite32 (LAN9118_TX_CFG, TxCfg);
-    MemoryFence();
+    gBS->Stall (LAN9118_STALL);
   }
 
   // Check if already stopped
@@ -694,7 +690,7 @@ StopTx (
     if (TxCfg & TXCFG_TX_ON) {
       TxCfg |= TXCFG_STOP_TX;
       MmioWrite32 (LAN9118_TX_CFG, TxCfg);
-      MemoryFence();
+      gBS->Stall (LAN9118_STALL);
 
       // Wait for Tx to finish transmitting
       while (MmioRead32 (LAN9118_TX_CFG) & TXCFG_STOP_TX);
@@ -729,7 +725,7 @@ StopRx (
     RxCfg = MmioRead32 (LAN9118_RX_CFG);
     RxCfg |= RXCFG_RX_DUMP;
     MmioWrite32 (LAN9118_RX_CFG, RxCfg);
-    MemoryFence();
+    gBS->Stall (LAN9118_STALL);
 
     while (MmioRead32 (LAN9118_RX_CFG) & RXCFG_RX_DUMP);
   }
@@ -755,28 +751,28 @@ StartTx (
     TxCfg = MmioRead32 (LAN9118_TX_CFG);
     TxCfg |= TXCFG_TXS_DUMP | TXCFG_TXD_DUMP;
     MmioWrite32 (LAN9118_TX_CFG, TxCfg);
-    MemoryFence();
+    gBS->Stall (LAN9118_STALL);
   }
 
   // Check if tx was started from MAC and enable if not
   if (Flags & START_TX_MAC) {
     MacCsr = IndirectMACRead32 (INDIRECT_MAC_INDEX_CR);
-    MemoryFence();
+    gBS->Stall (LAN9118_STALL);
     if ((MacCsr & MACCR_TX_EN) == 0) {
       MacCsr |= MACCR_TX_EN;
       IndirectMACWrite32 (INDIRECT_MAC_INDEX_CR, MacCsr);
-      MemoryFence();
+      gBS->Stall (LAN9118_STALL);
     }
   }
 
   // Check if tx was started from TX_CFG and enable if not
   if (Flags & START_TX_CFG) {
     TxCfg = MmioRead32 (LAN9118_TX_CFG);
-    MemoryFence();
+    gBS->Stall (LAN9118_STALL);
     if ((TxCfg & TXCFG_TX_ON) == 0) {
       TxCfg |= TXCFG_TX_ON;
       MmioWrite32 (LAN9118_TX_CFG, TxCfg);
-      MemoryFence();
+      gBS->Stall (LAN9118_STALL);
     }
   }
 
@@ -806,14 +802,14 @@ StartRx (
       RxCfg = MmioRead32 (LAN9118_RX_CFG);
       RxCfg |= RXCFG_RX_DUMP;
       MmioWrite32 (LAN9118_RX_CFG, RxCfg);
-      MemoryFence();
+      gBS->Stall (LAN9118_STALL);
 
       while (MmioRead32 (LAN9118_RX_CFG) & RXCFG_RX_DUMP);
     }
 
     MacCsr |= MACCR_RX_EN;
     IndirectMACWrite32 (INDIRECT_MAC_INDEX_CR, MacCsr);
-    MemoryFence();
+    gBS->Stall (LAN9118_STALL);
   }
 
   return EFI_SUCCESS;
@@ -1003,7 +999,7 @@ ChangeFifoAllocation (
   HwConf &= ~(0xF0000);
   HwConf |= ((TxFifoOption & 0xF) << 16);
   MmioWrite32 (LAN9118_HW_CFG, HwConf);
-  MemoryFence();
+  gBS->Stall (LAN9118_STALL);
 
   return EFI_SUCCESS;
 }