Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6: (1674 commits)
  qlcnic: adding co maintainer
  ixgbe: add support for active DA cables
  ixgbe: dcb, do not tag tc_prio_control frames
  ixgbe: fix ixgbe_tx_is_paused logic
  ixgbe: always enable vlan strip/insert when DCB is enabled
  ixgbe: remove some redundant code in setting FCoE FIP filter
  ixgbe: fix wrong offset to fc_frame_header in ixgbe_fcoe_ddp
  ixgbe: fix header len when unsplit packet overflows to data buffer
  ipv6: Never schedule DAD timer on dead address
  ipv6: Use POSTDAD state
  ipv6: Use state_lock to protect ifa state
  ipv6: Replace inet6_ifaddr->dead with state
  cxgb4: notify upper drivers if the device is already up when they load
  cxgb4: keep interrupts available when the ports are brought down
  cxgb4: fix initial addition of MAC address
  cnic: Return SPQ credit to bnx2x after ring setup and shutdown.
  cnic: Convert cnic_local_flags to atomic ops.
  can: Fix SJA1000 command register writes on SMP systems
  bridge: fix build for CONFIG_SYSFS disabled
  ARCNET: Limit com20020 PCI ID matches for SOHARD cards
  ...

Fix up various conflicts with pcmcia tree drivers/net/
{pcmcia/3c589_cs.c, wireless/orinoco/orinoco_cs.c and
wireless/orinoco/spectrum_cs.c} and feature removal
(Documentation/feature-removal-schedule.txt).

Also fix a non-content conflict due to pm_qos_requirement getting
renamed in the PM tree (now pm_qos_request) in net/mac80211/scan.c

1 files changed, 9 insertions, 9 deletions

diff --git a/drivers/net/wireless/prism54/islpci_dev.c b/drivers/net/wireless/prism54/islpci_dev.c
index 689d59a13d5..2c8cc954d1b 100644
--- a/drivers/net/wireless/prism54/islpci_dev.c
+++ b/drivers/net/wireless/prism54/islpci_dev.c
@@ -228,14 +228,14 @@ islpci_interrupt(int irq, void *config)
 
 #if VERBOSE > SHOW_ERROR_MESSAGES
 		DEBUG(SHOW_FUNCTION_CALLS,
-		      "IRQ: Identification register 0x%p 0x%x \n", device, reg);
+		      "IRQ: Identification register 0x%p 0x%x\n", device, reg);
 #endif
 
 		/* check for each bit in the register separately */
 		if (reg & ISL38XX_INT_IDENT_UPDATE) {
 #if VERBOSE > SHOW_ERROR_MESSAGES
 			/* Queue has been updated */
-			DEBUG(SHOW_TRACING, "IRQ: Update flag \n");
+			DEBUG(SHOW_TRACING, "IRQ: Update flag\n");
 
 			DEBUG(SHOW_QUEUE_INDEXES,
 			      "CB drv Qs: [%i][%i][%i][%i][%i][%i]\n",
@@ -301,7 +301,7 @@ islpci_interrupt(int irq, void *config)
 						ISL38XX_CB_RX_DATA_LQ) != 0) {
 #if VERBOSE > SHOW_ERROR_MESSAGES
 				DEBUG(SHOW_TRACING,
-				      "Received frame in Data Low Queue \n");
+				      "Received frame in Data Low Queue\n");
 #endif
 				islpci_eth_receive(priv);
 			}
@@ -326,7 +326,7 @@ islpci_interrupt(int irq, void *config)
 			/* Device has been initialized */
 #if VERBOSE > SHOW_ERROR_MESSAGES
 			DEBUG(SHOW_TRACING,
-			      "IRQ: Init flag, device initialized \n");
+			      "IRQ: Init flag, device initialized\n");
 #endif
 			wake_up(&priv->reset_done);
 		}
@@ -334,7 +334,7 @@ islpci_interrupt(int irq, void *config)
 		if (reg & ISL38XX_INT_IDENT_SLEEP) {
 			/* Device intends to move to powersave state */
 #if VERBOSE > SHOW_ERROR_MESSAGES
-			DEBUG(SHOW_TRACING, "IRQ: Sleep flag \n");
+			DEBUG(SHOW_TRACING, "IRQ: Sleep flag\n");
 #endif
 			isl38xx_handle_sleep_request(priv->control_block,
 						     &powerstate,
@@ -344,7 +344,7 @@ islpci_interrupt(int irq, void *config)
 		if (reg & ISL38XX_INT_IDENT_WAKEUP) {
 			/* Device has been woken up to active state */
 #if VERBOSE > SHOW_ERROR_MESSAGES
-			DEBUG(SHOW_TRACING, "IRQ: Wakeup flag \n");
+			DEBUG(SHOW_TRACING, "IRQ: Wakeup flag\n");
 #endif
 
 			isl38xx_handle_wakeup(priv->control_block,
@@ -635,7 +635,7 @@ islpci_alloc_memory(islpci_private *priv)
 	      ioremap(pci_resource_start(priv->pdev, 0),
 		      ISL38XX_PCI_MEM_SIZE))) {
 		/* error in remapping the PCI device memory address range */
-		printk(KERN_ERR "PCI memory remapping failed \n");
+		printk(KERN_ERR "PCI memory remapping failed\n");
 		return -1;
 	}
 
@@ -902,7 +902,7 @@ islpci_setup(struct pci_dev *pdev)
 
 	if (register_netdev(ndev)) {
 		DEBUG(SHOW_ERROR_MESSAGES,
-		      "ERROR: register_netdev() failed \n");
+		      "ERROR: register_netdev() failed\n");
 		goto do_islpci_free_memory;
 	}
 
@@ -946,7 +946,7 @@ islpci_set_state(islpci_private *priv, islpci_state_t new_state)
 		if (!priv->state_off)
 			priv->state = new_state;
 		break;
-	};
+	}
 #if 0
 	printk(KERN_DEBUG "%s: state transition %d -> %d (off#%d)\n",
 	       priv->ndev->name, old_state, new_state, priv->state_off);