diff options
| -rw-r--r-- | Documentation/devicetree/bindings/mmc/synposis-dw-mshc.txt | 79 | ||||
| -rw-r--r-- | drivers/mmc/host/dw_mmc-pltfm.c | 9 | ||||
| -rw-r--r-- | drivers/mmc/host/dw_mmc.c | 130 |
3 files changed, 211 insertions, 7 deletions
diff --git a/Documentation/devicetree/bindings/mmc/synposis-dw-mshc.txt b/Documentation/devicetree/bindings/mmc/synposis-dw-mshc.txt new file mode 100644 index 00000000000..06cd32d0805 --- /dev/null +++ b/Documentation/devicetree/bindings/mmc/synposis-dw-mshc.txt @@ -0,0 +1,79 @@ +* Synopsis Designware Mobile Storage Host Controller + +The Synopsis designware mobile storage host controller is used to interface +a SoC with storage medium such as eMMC or SD/MMC cards. This file documents +differences between the core mmc properties described by mmc.txt and the +properties used by the Synopsis Designware Mobile Storage Host Controller. + +Required Properties: + +* compatible: should be + - snps,dw-mshc: for controllers compliant with synopsis dw-mshc. +* #address-cells: should be 1. +* #size-cells: should be 0. + +# Slots: The slot specific information are contained within child-nodes with + each child-node representing a supported slot. There should be atleast one + child node representing a card slot. The name of the child node representing + the slot is recommended to be slot@n where n is the unique number of the slot + connnected to the controller. The following are optional properties which + can be included in the slot child node. + + * reg: specifies the physical slot number. The valid values of this + property is 0 to (num-slots -1), where num-slots is the value + specified by the num-slots property. + + * bus-width: as documented in mmc core bindings. + + * wp-gpios: specifies the write protect gpio line. The format of the + gpio specifier depends on the gpio controller. If the write-protect + line is not available, this property is optional. + +Optional properties: + +* num-slots: specifies the number of slots supported by the controller. + The number of physical slots actually used could be equal or less than the + value specified by num-slots. If this property is not specified, the value + of num-slot property is assumed to be 1. + +* fifo-depth: The maximum size of the tx/rx fifo's. If this property is not + specified, the default value of the fifo size is determined from the + controller registers. + +* card-detect-delay: Delay in milli-seconds before detecting card after card + insert event. The default value is 0. + +* supports-highspeed: Enables support for high speed cards (upto 50MHz) + +* broken-cd: as documented in mmc core bindings. + +Aliases: + +- All the MSHC controller nodes should be represented in the aliases node using + the following format 'mshc{n}' where n is a unique number for the alias. + +Example: + +The MSHC controller node can be split into two portions, SoC specific and +board specific portions as listed below. + + dwmmc0@12200000 { + compatible = "snps,dw-mshc"; + reg = <0x12200000 0x1000>; + interrupts = <0 75 0>; + #address-cells = <1>; + #size-cells = <0>; + }; + + dwmmc0@12200000 { + num-slots = <1>; + supports-highspeed; + broken-cd; + fifo-depth = <0x80>; + card-detect-delay = <200>; + + slot@0 { + reg = <0>; + bus-width = <8>; + }; + }; diff --git a/drivers/mmc/host/dw_mmc-pltfm.c b/drivers/mmc/host/dw_mmc-pltfm.c index ce7be1ac662..72059050540 100644 --- a/drivers/mmc/host/dw_mmc-pltfm.c +++ b/drivers/mmc/host/dw_mmc-pltfm.c @@ -19,6 +19,8 @@ #include <linux/mmc/host.h> #include <linux/mmc/mmc.h> #include <linux/mmc/dw_mmc.h> +#include <linux/of.h> + #include "dw_mmc.h" static int __devinit dw_mci_pltfm_probe(struct platform_device *pdev) @@ -94,10 +96,17 @@ static int dw_mci_pltfm_resume(struct device *dev) static SIMPLE_DEV_PM_OPS(dw_mci_pltfm_pmops, dw_mci_pltfm_suspend, dw_mci_pltfm_resume); +static const struct of_device_id dw_mci_pltfm_match[] = { + { .compatible = "snps,dw-mshc", }, + {}, +}; +MODULE_DEVICE_TABLE(of, dw_mci_pltfm_match); + static struct platform_driver dw_mci_pltfm_driver = { .remove = __exit_p(dw_mci_pltfm_remove), .driver = { .name = "dw_mmc", + .of_match_table = of_match_ptr(dw_mci_pltfm_match), .pm = &dw_mci_pltfm_pmops, }, }; diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c index 455a155406b..c792466fb8a 100644 --- a/drivers/mmc/host/dw_mmc.c +++ b/drivers/mmc/host/dw_mmc.c @@ -33,6 +33,7 @@ #include <linux/bitops.h> #include <linux/regulator/consumer.h> #include <linux/workqueue.h> +#include <linux/of.h> #include "dw_mmc.h" @@ -1769,10 +1770,57 @@ static void dw_mci_work_routine_card(struct work_struct *work) } } +#ifdef CONFIG_OF +/* given a slot id, find out the device node representing that slot */ +static struct device_node *dw_mci_of_find_slot_node(struct device *dev, u8 slot) +{ + struct device_node *np; + const __be32 *addr; + int len; + + if (!dev || !dev->of_node) + return NULL; + + for_each_child_of_node(dev->of_node, np) { + addr = of_get_property(np, "reg", &len); + if (!addr || (len < sizeof(int))) + continue; + if (be32_to_cpup(addr) == slot) + return np; + } + return NULL; +} + +/* find out bus-width for a given slot */ +static u32 dw_mci_of_get_bus_wd(struct device *dev, u8 slot) +{ + struct device_node *np = dw_mci_of_find_slot_node(dev, slot); + u32 bus_wd = 1; + + if (!np) + return 1; + + if (of_property_read_u32(np, "bus-width", &bus_wd)) + dev_err(dev, "bus-width property not found, assuming width" + " as 1\n"); + return bus_wd; +} +#else /* CONFIG_OF */ +static u32 dw_mci_of_get_bus_wd(struct device *dev, u8 slot) +{ + return 1; +} +static struct device_node *dw_mci_of_find_slot_node(struct device *dev, u8 slot) +{ + return NULL; +} +#endif /* CONFIG_OF */ + static int dw_mci_init_slot(struct dw_mci *host, unsigned int id) { struct mmc_host *mmc; struct dw_mci_slot *slot; + u8 bus_width; mmc = mmc_alloc_host(sizeof(struct dw_mci_slot), host->dev); if (!mmc) @@ -1782,6 +1830,7 @@ static int dw_mci_init_slot(struct dw_mci *host, unsigned int id) slot->id = id; slot->mmc = mmc; slot->host = host; + host->slot[id] = slot; mmc->ops = &dw_mci_ops; mmc->f_min = DIV_ROUND_UP(host->bus_hz, 510); @@ -1806,8 +1855,18 @@ static int dw_mci_init_slot(struct dw_mci *host, unsigned int id) mmc->caps2 = host->pdata->caps2; if (host->pdata->get_bus_wd) - if (host->pdata->get_bus_wd(slot->id) >= 4) - mmc->caps |= MMC_CAP_4_BIT_DATA; + bus_width = host->pdata->get_bus_wd(slot->id); + else if (host->dev->of_node) + bus_width = dw_mci_of_get_bus_wd(host->dev, slot->id); + else + bus_width = 1; + + switch (bus_width) { + case 8: + mmc->caps |= MMC_CAP_8_BIT_DATA; + case 4: + mmc->caps |= MMC_CAP_4_BIT_DATA; + } if (host->pdata->quirks & DW_MCI_QUIRK_HIGHSPEED) mmc->caps |= MMC_CAP_SD_HIGHSPEED | MMC_CAP_MMC_HIGHSPEED; @@ -1852,7 +1911,6 @@ static int dw_mci_init_slot(struct dw_mci *host, unsigned int id) else clear_bit(DW_MMC_CARD_PRESENT, &slot->flags); - host->slot[id] = slot; mmc_add_host(mmc); #if defined(CONFIG_DEBUG_FS) @@ -1944,16 +2002,74 @@ static bool mci_wait_reset(struct device *dev, struct dw_mci *host) return false; } +#ifdef CONFIG_OF +static struct dw_mci_of_quirks { + char *quirk; + int id; +} of_quirks[] = { + { + .quirk = "supports-highspeed", + .id = DW_MCI_QUIRK_HIGHSPEED, + }, { + .quirk = "broken-cd", + .id = DW_MCI_QUIRK_BROKEN_CARD_DETECTION, + }, +}; + +static struct dw_mci_board *dw_mci_parse_dt(struct dw_mci *host) +{ + struct dw_mci_board *pdata; + struct device *dev = host->dev; + struct device_node *np = dev->of_node; + int idx; + + pdata = devm_kzalloc(dev, sizeof(*pdata), GFP_KERNEL); + if (!pdata) { + dev_err(dev, "could not allocate memory for pdata\n"); + return ERR_PTR(-ENOMEM); + } + + /* find out number of slots supported */ + if (of_property_read_u32(dev->of_node, "num-slots", + &pdata->num_slots)) { + dev_info(dev, "num-slots property not found, " + "assuming 1 slot is available\n"); + pdata->num_slots = 1; + } + + /* get quirks */ + for (idx = 0; idx < ARRAY_SIZE(of_quirks); idx++) + if (of_get_property(np, of_quirks[idx].quirk, NULL)) + pdata->quirks |= of_quirks[idx].id; + + if (of_property_read_u32(np, "fifo-depth", &pdata->fifo_depth)) + dev_info(dev, "fifo-depth property not found, using " + "value of FIFOTH register as default\n"); + + of_property_read_u32(np, "card-detect-delay", &pdata->detect_delay_ms); + + return pdata; +} + +#else /* CONFIG_OF */ +static struct dw_mci_board *dw_mci_parse_dt(struct dw_mci *host) +{ + return ERR_PTR(-EINVAL); +} +#endif /* CONFIG_OF */ + int dw_mci_probe(struct dw_mci *host) { int width, i, ret = 0; u32 fifo_size; int init_slots = 0; - if (!host->pdata || !host->pdata->init) { - dev_err(host->dev, - "Platform data must supply init function\n"); - return -ENODEV; + if (!host->pdata) { + host->pdata = dw_mci_parse_dt(host); + if (IS_ERR(host->pdata)) { + dev_err(host->dev, "platform data not available\n"); + return -EINVAL; + } } if (!host->pdata->select_slot && host->pdata->num_slots > 1) { |