diff options
Diffstat (limited to 'Documentation/devicetree/bindings/mmc/samsung-sdhci.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/mmc/samsung-sdhci.txt | 35 |
1 files changed, 4 insertions, 31 deletions
diff --git a/Documentation/devicetree/bindings/mmc/samsung-sdhci.txt b/Documentation/devicetree/bindings/mmc/samsung-sdhci.txt index 3b3a1ee055f..328e990d254 100644 --- a/Documentation/devicetree/bindings/mmc/samsung-sdhci.txt +++ b/Documentation/devicetree/bindings/mmc/samsung-sdhci.txt @@ -5,13 +5,6 @@ MMC, SD and eMMC storage mediums. This file documents differences between the core mmc properties described by mmc.txt and the properties used by the Samsung implmentation of the SDHCI controller. -Note: The mmc core bindings documentation states that if none of the core -card-detect bindings are used, then the standard sdhci card detect mechanism -is used. The Samsung's SDHCI controller bindings extends this as listed below. - -[A] The property "samsung,cd-pinmux-gpio" can be used as stated in the - "Optional Board Specific Properties" section below. - Required SoC Specific Properties: - compatible: should be one of the following - "samsung,s3c6410-sdhci": For controllers compatible with s3c6410 sdhci @@ -20,18 +13,8 @@ Required SoC Specific Properties: controller. Required Board Specific Properties: -- Samsung GPIO variant (will be completely replaced by pinctrl): - - gpios: Should specify the gpios used for clock, command and data lines. The - gpio specifier format depends on the gpio controller. -- Pinctrl variant (preferred if available): - - pinctrl-0: Should specify pin control groups used for this controller. - - pinctrl-names: Should contain only one value - "default". - -Optional Board Specific Properties: -- samsung,cd-pinmux-gpio: Specifies the card detect line that is routed - through a pinmux to the card-detect pin of the card slot. This property - should be used only if none of the mmc core card-detect properties are - used. Only for Samsung GPIO variant. +- pinctrl-0: Should specify pin control groups used for this controller. +- pinctrl-names: Should contain only one value - "default". Example: sdhci@12530000 { @@ -39,19 +22,9 @@ Example: reg = <0x12530000 0x100>; interrupts = <0 75 0>; bus-width = <4>; - cd-gpios = <&gpk2 2 2 3 3>; - - /* Samsung GPIO variant */ - gpios = <&gpk2 0 2 0 3>, /* clock line */ - <&gpk2 1 2 0 3>, /* command line */ - <&gpk2 3 2 3 3>, /* data line 0 */ - <&gpk2 4 2 3 3>, /* data line 1 */ - <&gpk2 5 2 3 3>, /* data line 2 */ - <&gpk2 6 2 3 3>; /* data line 3 */ - - /* Pinctrl variant */ - pinctrl-0 = <&sd0_clk &sd0_cmd &sd0_bus4>; + cd-gpios = <&gpk2 2 0>; pinctrl-names = "default"; + pinctrl-0 = <&sd0_clk &sd0_cmd &sd0_bus4>; }; Note: This example shows both SoC specific and board specific properties |