aboutsummaryrefslogtreecommitdiff
path: root/drivers/net/ethernet/intel/e1000e/defines.h
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/net/ethernet/intel/e1000e/defines.h')
-rw-r--r--drivers/net/ethernet/intel/e1000e/defines.h27
1 files changed, 9 insertions, 18 deletions
diff --git a/drivers/net/ethernet/intel/e1000e/defines.h b/drivers/net/ethernet/intel/e1000e/defines.h
index 76edbc1be33..02a12b69555 100644
--- a/drivers/net/ethernet/intel/e1000e/defines.h
+++ b/drivers/net/ethernet/intel/e1000e/defines.h
@@ -185,8 +185,7 @@
#define E1000_RCTL_BSEX 0x02000000 /* Buffer size extension */
#define E1000_RCTL_SECRC 0x04000000 /* Strip Ethernet CRC */
-/*
- * Use byte values for the following shift parameters
+/* Use byte values for the following shift parameters
* Usage:
* psrctl |= (((ROUNDUP(value0, 128) >> E1000_PSRCTL_BSIZE0_SHIFT) &
* E1000_PSRCTL_BSIZE0_MASK) |
@@ -242,8 +241,7 @@
#define E1000_CTRL_VME 0x40000000 /* IEEE VLAN mode enable */
#define E1000_CTRL_PHY_RST 0x80000000 /* PHY Reset */
-/*
- * Bit definitions for the Management Data IO (MDIO) and Management Data
+/* Bit definitions for the Management Data IO (MDIO) and Management Data
* Clock (MDC) pins in the Device Control Register.
*/
@@ -424,8 +422,7 @@
#define E1000_PBA_ECC_STAT_CLR 0x00000002 /* Clear ECC error counter */
#define E1000_PBA_ECC_INT_EN 0x00000004 /* Enable ICR bit 5 for ECC */
-/*
- * This defines the bits that are set in the Interrupt Mask
+/* This defines the bits that are set in the Interrupt Mask
* Set/Read Register. Each bit is documented below:
* o RXT0 = Receiver Timer Interrupt (ring 0)
* o TXDW = Transmit Descriptor Written Back
@@ -475,8 +472,7 @@
/* 802.1q VLAN Packet Size */
#define E1000_VLAN_FILTER_TBL_SIZE 128 /* VLAN Filter Table (4096 bits) */
-/* Receive Address */
-/*
+/* Receive Address
* Number of high/low register pairs in the RAR. The RAR (Receive Address
* Registers) holds the directed and multicast addresses that we monitor.
* Technically, we have 16 spots. However, we reserve one of these spots
@@ -723,8 +719,7 @@
#define MAX_PHY_REG_ADDRESS 0x1F /* 5 bit address bus (0-0x1F) */
#define MAX_PHY_MULTI_PAGE_REG 0xF
-/* Bit definitions for valid PHY IDs. */
-/*
+/* Bit definitions for valid PHY IDs.
* I = Integrated
* E = External
*/
@@ -762,8 +757,7 @@
#define M88E1000_PSCR_AUTO_X_1000T 0x0040
/* Auto crossover enabled all speeds */
#define M88E1000_PSCR_AUTO_X_MODE 0x0060
-/*
- * 1=Enable Extended 10BASE-T distance (Lower 10BASE-T Rx Threshold)
+/* 1=Enable Extended 10BASE-T distance (Lower 10BASE-T Rx Threshold)
* 0=Normal 10BASE-T Rx Threshold
*/
#define M88E1000_PSCR_ASSERT_CRS_ON_TX 0x0800 /* 1=Assert CRS on Transmit */
@@ -779,14 +773,12 @@
#define M88E1000_PSSR_CABLE_LENGTH_SHIFT 7
-/*
- * Number of times we will attempt to autonegotiate before downshifting if we
+/* Number of times we will attempt to autonegotiate before downshifting if we
* are the master
*/
#define M88E1000_EPSCR_MASTER_DOWNSHIFT_MASK 0x0C00
#define M88E1000_EPSCR_MASTER_DOWNSHIFT_1X 0x0000
-/*
- * Number of times we will attempt to autonegotiate before downshifting if we
+/* Number of times we will attempt to autonegotiate before downshifting if we
* are the slave
*/
#define M88E1000_EPSCR_SLAVE_DOWNSHIFT_MASK 0x0300
@@ -808,8 +800,7 @@
#define PHY_REG(page, reg) (((page) << PHY_PAGE_SHIFT) | \
((reg) & MAX_PHY_REG_ADDRESS))
-/*
- * Bits...
+/* Bits...
* 15-5: page
* 4-0: register offset
*/