/* * PMC-Sierra SPC 8001 SAS/SATA based host adapters driver * * Copyright (c) 2008-2009 USI Co., Ltd. * All rights reserved. * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions * are met: * 1. Redistributions of source code must retain the above copyright * notice, this list of conditions, and the following disclaimer, * without modification. * 2. Redistributions in binary form must reproduce at minimum a disclaimer * substantially similar to the "NO WARRANTY" disclaimer below * ("Disclaimer") and any redistribution must be conditioned upon * including a substantially similar Disclaimer requirement for further * binary redistribution. * 3. Neither the names of the above-listed copyright holders nor the names * of any contributors may be used to endorse or promote products derived * from this software without specific prior written permission. * * Alternatively, this software may be distributed under the terms of the * GNU General Public License ("GPL") version 2 as published by the Free * Software Foundation. * * NO WARRANTY * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTIBILITY AND FITNESS FOR * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT * HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY, OR CONSEQUENTIAL * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, * STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING * IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE * POSSIBILITY OF SUCH DAMAGES. * */ #ifndef _PM8001_DEFS_H_ #define _PM8001_DEFS_H_ enum chip_flavors { chip_8001, }; #define USI_MAX_MEMCNT 9 #define PM8001_MAX_DMA_SG SG_ALL enum phy_speed { PHY_SPEED_15 = 0x01, PHY_SPEED_30 = 0x02, PHY_SPEED_60 = 0x04, }; enum data_direction { DATA_DIR_NONE = 0x0, /* NO TRANSFER */ DATA_DIR_IN = 0x01, /* INBOUND */ DATA_DIR_OUT = 0x02, /* OUTBOUND */ DATA_DIR_BYRECIPIENT = 0x04, /* UNSPECIFIED */ }; enum port_type { PORT_TYPE_SAS = (1L << 1), PORT_TYPE_SATA = (1L << 0), }; /* driver compile-time configuration */ #define PM8001_MAX_CCB 512 /* max ccbs supported */ #define PM8001_MAX_INB_NUM 1 #define PM8001_MAX_OUTB_NUM 1 #define PM8001_CAN_QUEUE 128 /* SCSI Queue depth */ /* unchangeable hardware details */ #define PM8001_MAX_PHYS 8 /* max. possible phys */ #define PM8001_MAX_PORTS 8 /* max. possible ports */ #define PM8001_MAX_DEVICES 1024 /* max supported device */ enum memory_region_num { AAP1 = 0x0, /* application acceleration processor */ IOP, /* IO processor */ CI, /* consumer index */ PI, /* producer index */ IB, /* inbound queue */ OB, /* outbound queue */ NVMD, /* NVM device */ DEV_MEM, /* memory for devices */ CCB_MEM, /* memory for command control block */ }; #define PM8001_EVENT_LOG_SIZE (128 * 1024) /*error code*/ enum mpi_err { MPI_IO_STATUS_SUCCESS = 0x0, MPI_IO_STATUS_BUSY = 0x01, MPI_IO_STATUS_FAIL = 0x02, }; /** * Phy Control constants */ enum phy_control_type { PHY_LINK_RESET = 0x01, PHY_HARD_RESET = 0x02, PHY_NOTIFY_ENABLE_SPINUP = 0x10, }; enum pm8001_hba_info_flags { PM8001F_INIT_TIME = (1U << 0), PM8001F_RUN_TIME = (1U << 1), }; #endif