/* * Copyright 2011-2012 Analog Devices Inc. * * Licensed under the GPL-2. * */ #include #include #include #include #include #include #include #include #include #include "ad7606.h" /** * ad7606_trigger_handler_th() th/bh of trigger launched polling to ring buffer * **/ static irqreturn_t ad7606_trigger_handler_th_bh(int irq, void *p) { struct iio_poll_func *pf = p; struct ad7606_state *st = iio_priv(pf->indio_dev); gpio_set_value(st->pdata->gpio_convst, 1); return IRQ_HANDLED; } /** * ad7606_poll_bh_to_ring() bh of trigger launched polling to ring buffer * @work_s: the work struct through which this was scheduled * * Currently there is no option in this driver to disable the saving of * timestamps within the ring. * I think the one copy of this at a time was to avoid problems if the * trigger was set far too high and the reads then locked up the computer. **/ static void ad7606_poll_bh_to_ring(struct work_struct *work_s) { struct ad7606_state *st = container_of(work_s, struct ad7606_state, poll_work); struct iio_dev *indio_dev = iio_priv_to_dev(st); s64 time_ns; __u8 *buf; int ret; buf = kzalloc(indio_dev->scan_bytes, GFP_KERNEL); if (buf == NULL) return; if (gpio_is_valid(st->pdata->gpio_frstdata)) { ret = st->bops->read_block(st->dev, 1, buf); if (ret) goto done; if (!gpio_get_value(st->pdata->gpio_frstdata)) { /* This should never happen. However * some signal glitch caused by bad PCB desgin or * electrostatic discharge, could cause an extra read * or clock. This allows recovery. */ ad7606_reset(st); goto done; } ret = st->bops->read_block(st->dev, st->chip_info->num_channels - 1, buf + 2); if (ret) goto done; } else { ret = st->bops->read_block(st->dev, st->chip_info->num_channels, buf); if (ret) goto done; } time_ns = iio_get_time_ns(); if (indio_dev->scan_timestamp) *((s64 *)(buf + indio_dev->scan_bytes - sizeof(s64))) = time_ns; iio_push_to_buffers(indio_dev, buf); done: gpio_set_value(st->pdata->gpio_convst, 0); iio_trigger_notify_done(indio_dev->trig); kfree(buf); } int ad7606_register_ring_funcs_and_init(struct iio_dev *indio_dev) { struct ad7606_state *st = iio_priv(indio_dev); INIT_WORK(&st->poll_work, &ad7606_poll_bh_to_ring); return iio_triggered_buffer_setup(indio_dev, &ad7606_trigger_handler_th_bh, &ad7606_trigger_handler_th_bh, NULL); } void ad7606_ring_cleanup(struct iio_dev *indio_dev) { iio_triggered_buffer_cleanup(indio_dev); }