diff options
Diffstat (limited to 'Documentation/devicetree/bindings/regulator/regulator.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/regulator/regulator.txt | 18 |
1 files changed, 17 insertions, 1 deletions
diff --git a/Documentation/devicetree/bindings/regulator/regulator.txt b/Documentation/devicetree/bindings/regulator/regulator.txt index 1d112fc456aa..378f6dc8b8bd 100644 --- a/Documentation/devicetree/bindings/regulator/regulator.txt +++ b/Documentation/devicetree/bindings/regulator/regulator.txt @@ -13,7 +13,7 @@ Optional properties: - regulator-allow-bypass: allow the regulator to go into bypass mode - regulator-allow-set-load: allow the regulator performance level to be configured - <name>-supply: phandle to the parent supply/regulator node -- regulator-ramp-delay: ramp delay for regulator(in uV/uS) +- regulator-ramp-delay: ramp delay for regulator(in uV/us) For hardware which supports disabling ramp rate, it should be explicitly initialised to zero (regulator-ramp-delay = <0>) for disabling ramp delay. - regulator-enable-ramp-delay: The time taken, in microseconds, for the supply @@ -21,6 +21,17 @@ Optional properties: design requires. This property describes the total system ramp time required due to the combination of internal ramping of the regulator itself, and board design issues such as trace capacitance and load on the supply. +- regulator-settling-time-us: Settling time, in microseconds, for voltage + change if regulator have the constant time for any level voltage change. + This is useful when regulator have exponential voltage change. +- regulator-settling-time-up-us: Settling time, in microseconds, for voltage + increase if the regulator needs a constant time to settle after voltage + increases of any level. This is useful for regulators with exponential + voltage changes. +- regulator-settling-time-down-us: Settling time, in microseconds, for voltage + decrease if the regulator needs a constant time to settle after voltage + decreases of any level. This is useful for regulators with exponential + voltage changes. - regulator-soft-start: Enable soft start so that voltage ramps slowly - regulator-state-mem sub-root node for Suspend-to-RAM mode : suspend to memory, the device goes to sleep, but all data stored in memory, @@ -44,6 +55,11 @@ Optional properties: any consumer request. - regulator-pull-down: Enable pull down resistor when the regulator is disabled. - regulator-over-current-protection: Enable over current protection. +- regulator-active-discharge: tristate, enable/disable active discharge of + regulators. The values are: + 0: Disable active discharge. + 1: Enable active discharge. + Absence of this property will leave configuration to default. Deprecated properties: - regulator-compatible: If a regulator chip contains multiple |