index
:
working/broadcom/kernel.git
llct/capri-support
master
public-review/ARM-bcm_defconfig-Do-not-expect-appended-DTB
public-review/ARM-dts-Leave-sdio1-as-disabled-on-bcm28155-ap
public-review/ARM-dts-bcm28155-ap-Fix-Card-Detection-GPIO
public-review/Add-Broadcom-Kona-I2C-Support-v2-on-v3.13-rc2
public-review/Add-Broadcom-Kona-PWM-Support-v1
public-review/Add-Broadcom-Kona-PWM-Support-v1-on-v3.12-rc2
public-review/Add-Broadcom-Kona-PWM-Support-v2
public-review/Add-Broadcom-Kona-PWM-Support-v5
public-review/Enable-I2C-on-bcm-28155-ap
public-review/Improve-support-for-deferred-regulators-v2
public-review/Set-n_voltages-for-linear-reg
public-review/Try-other-signal-levels-during-power-up-v2
public-review/Update-Kona-drivers-to-use-clocks-v4
public-review/Update-bcm_defconfig
public-review/Use-mmc-core-regulator-infrastucture
public-review/clocksource-kona-Print-warning-rather-than-panic
pull/spear-clocksource-init
review/ARM-DT-Add-missing-UARTs-for-bcm11351-bcm281xx
review/ARM-bcm281xx-Board-specific-reboot-code-v1
review/ARM-bcm281xx-Board-specific-reboot-code-v2
review/ARM-bcm281xx-Board-specific-reboot-code-v3
review/ARM-bcm281xx-GPIO-driver-v1
review/ARM-bcm281xx-TMON-driver-v1
review/ARM-bcm281xx-TMON-driver-v2
review/ARM-bcm281xx-adding-bcm28155-ap-dts-v1
review/ARM-bcm281xx-thermal-v1
review/ARM-bcm281xx-thermal-v2
review/ARM-bcm281xx-turn-on-l2-cache-v1
review/ARM-bcm281xx-turn-on-socket-network-support-v1
review/ARM-dts-bcm28155-ap-Fix-Card-Detection-GPIO
review/Add-Broadcom-Kona-I2C-Support-v1
review/Update-Kona-drivers-to-use-clocks-v1
review/Update-Kona-drivers-to-use-clocks-v2
review/arm-configs-bcm-remove-debug-ll-v1
review/bcm-bus-clk-v5
review/bcm-bus-clk-v6
review/bcm-smp-v4
review/bcm-smp-v5
review/bcm-smp-v6
review/bcm281xx-udc-v1
review/bcm281xx-udc-v3
review/bcm281xx-udc-v4
review/bcm281xx-udc-v5
review/bcm281xx-udc-v9
review/bcm2835
review/bcm59056-pmu-v1
review/bcm59056-pmu-v2
review/bcm59056-pmu-v3
review/bcm59056-pmu-v4
review/bcm59056-pmu-v5
review/bcm59056-reboot-fix
review/bcm590xx-add-addtl-regulators-v1
review/bcm590xx-add-addtl-regulators-v2
review/capri-boot-3.15-v1
review/capri-smp
review/clang-asm
review/do_syslog_tweak
review/dw8250_clock
review/dw8250_clock-v2
review/dw8250_clock-v3
review/enable-method-bindings-v3
review/enable-method-bindings-v4
review/gpio-centralize-locking-v1
review/gpio-fix-parameter-v1
review/gpio-get-v1
review/gpio-get-v2
review/gpio-irq-handler-v1
review/gpio-setup-message
review/gpio-unsigned-fix-v1
review/hawaii-v1
review/hawaii-v2
review/minor-printk-fixes
review/minor-printk-fixes-v2
review/mmc-card-event
review/mmc-for-tkryger-v2
review/mmc-for-tkryger-v3
review/mmc-for-tkryger-v4
review/mmc-sdhci-bcm-kona-fix-nonremovable-test-v1
review/mmc-sdhci-bcm-kona-linker-section-warning-v1
review/mmc-sdhci-bcm-kona-make-warning-go-away-v1
review/more-printk-flags
review/more-printk-flags-v2
review/printk-flags-v6
review/printk-flags-v7
review/sdhci-cd
review/sdhci-cd-v2
review/sdhci-cd-v3
review/serial-8250_dw-Improve-unwritable-LCR-workaround-v2
review/watchdog-v1
rfc/watchdog-resolution
wip/bcm59056-pmu-v3
Broadcom Landing Team Kernel
about
summary
refs
log
tree
commit
diff
log msg
author
committer
range
path:
root
/
drivers
/
mtd
/
devices
Age
Commit message (
Expand
)
Author
2014-03-20
mtd: st_spi_fsm: Remove useless consts from function arguments
Lee Jones
2014-03-20
mtd: st_spi_fsm: Convert ST SPI FSM (NOR) Flash driver to new DT partitions
Lee Jones
2014-03-20
mtd: st_spi_fsm: Move runtime configurable msg sequences into device's struct
Lee Jones
2014-03-20
mtd: st_spi_fsm: Supply the W25Qxxx chip specific configuration call-back
Lee Jones
2014-03-20
mtd: st_spi_fsm: Supply the S25FLxxx chip specific configuration call-back
Lee Jones
2014-03-20
mtd: st_spi_fsm: Supply the MX25xxx chip specific configuration call-back
Lee Jones
2014-03-20
mtd: st_spi_fsm: Add the ability to write to FSM's status register
Lee Jones
2014-03-20
mtd: st_spi_fsm: Add the ability to read the FSM's status
Lee Jones
2014-03-20
mtd: st_spi_fsm: Erase partly or as a whole a Serial Flash device
Lee Jones
2014-03-20
mtd: st_spi_fsm: Supply a busy wait for post-write status
Lee Jones
2014-03-20
mtd: st_spi_fsm: Write to Flash via the FSM FIFO
Lee Jones
2014-03-20
mtd: st_spi_fsm: Add the ability to read from a Serial Flash device
Lee Jones
2014-03-20
mtd: st_spi_fsm: Prepare default sequences for read/write/erase
Lee Jones
2014-03-20
mtd: st_spi_fsm: Supply the N25Qxxx chip specific configuration call-back
Lee Jones
2014-03-20
mtd: st_spi_fsm: Supply the N25Qxxx specific read configurations
Lee Jones
2014-03-20
mtd: st_spi_fsm: Provide the default read/write configurations
Lee Jones
2014-03-20
mtd: st_spi_fsm: Update the flash Volatile Configuration Register
Lee Jones
2014-03-20
mtd: st_spi_fsm: Provide a method to put the chip into 32bit addressing mode
Lee Jones
2014-03-20
mtd: st_spi_fsm: Add a check to if the chip can handle an SoC reset
Lee Jones
2014-03-20
mtd: st_spi_fsm: Prepare read/write sequences according to configuration
Lee Jones
2014-03-20
mtd: st_spi_fsm: Provide the sequence for enabling 32bit addressing mode
Lee Jones
2014-03-20
mtd: st_spi_fsm: Provide the erase one sector sequence
Lee Jones
2014-03-20
mtd: st_spi_fsm: Fetch boot-device from mode pins
Lee Jones
2014-03-20
mtd: st_spi_fsm: Prepare the read/write FSM message sequence(s)
Lee Jones
2014-03-20
mtd: st_spi_fsm: Use device size to determine address width
Lee Jones
2014-03-20
mtd: st_spi_fsm: Search for preferred FSM message sequence configurations
Lee Jones
2014-03-20
mtd: st_spi_fsm: Dynamically setup flash device based on JEDEC ID
Lee Jones
2014-03-20
mtd: st_spi_fsm: Provide device look-up table
Lee Jones
2014-03-20
mtd: devices: Provide header for shared OPCODEs and SFDP commands
Lee Jones
2014-03-20
mtd: st_spi_fsm: Add support for JEDEC ID extraction
Lee Jones
2014-03-20
mtd: st_spi_fsm: Supply a method to read from the FSM's FIFO
Lee Jones
2014-03-20
mtd: st_spi_fsm: Supply framework for device requests
Lee Jones
2014-03-20
mtd: st_spi_fsm: Initialise and configure the FSM for normal working conditions
Lee Jones
2014-03-20
mtd: st_spi_fsm: Supply all register address and bit logic defines
Lee Jones
2014-03-20
mtd: st_spi_fsm: Allocate resources and register with MTD framework
Lee Jones
2014-03-10
mtd: Fix the behavior of OTP write if there is not enough room for data
Christian Riesch
2014-03-10
mtd: block2mtd: check device size
Fabian Frederick
2014-03-10
mtd: m25p80: add Macronix mx66l1g55g 1Gbit SPI flash
Brian Norris
2014-03-10
mtd: Add a retlen parameter to _get_{fact,user}_prot_info
Christian Riesch
2014-03-10
mtd: m25p80: add support for the Spansion s25fl008k chip
Kuninori Morimoto
2014-03-10
mtd: pmc551: Remove unnecessary OOM messages
Jingoo Han
2014-03-10
mtd: spear_smi: Remove unnecessary OOM messages
Jingoo Han
2014-03-10
mtd: devices: elm: Remove unnecessary OOM messages
Jingoo Han
2014-03-10
mtd: elm: Use correct check on return value of pm_runtime_get_sync
Stefan Sørensen
2014-03-10
mtd: m25p80: Use positive logic to check JEDEC ID
Axel Lin
2014-03-10
mtd: delete non-required instances of include <linux/init.h>
Paul Gortmaker
2014-03-10
mtd: block2mtd: Add mutex_destroy
Fabian Frederick
2014-03-10
mtd: phram: Repair multiple instances support
Alexander Sverdlin
2014-03-10
mtd: m25p80: Enable Dual SPI read transfers for s25fl256s1 and s25fl512s
Geert Uytterhoeven
2014-03-10
mtd: m25p80: Add dual read support
Geert Uytterhoeven
[next]