index
:
working/broadcom/kernel.git
llct/capri-support
master
public-review/ARM-bcm_defconfig-Do-not-expect-appended-DTB
public-review/ARM-dts-Leave-sdio1-as-disabled-on-bcm28155-ap
public-review/ARM-dts-bcm28155-ap-Fix-Card-Detection-GPIO
public-review/Add-Broadcom-Kona-I2C-Support-v2-on-v3.13-rc2
public-review/Add-Broadcom-Kona-PWM-Support-v1
public-review/Add-Broadcom-Kona-PWM-Support-v1-on-v3.12-rc2
public-review/Add-Broadcom-Kona-PWM-Support-v2
public-review/Add-Broadcom-Kona-PWM-Support-v5
public-review/Enable-I2C-on-bcm-28155-ap
public-review/Improve-support-for-deferred-regulators-v2
public-review/Set-n_voltages-for-linear-reg
public-review/Try-other-signal-levels-during-power-up-v2
public-review/Update-Kona-drivers-to-use-clocks-v4
public-review/Update-bcm_defconfig
public-review/Use-mmc-core-regulator-infrastucture
public-review/clocksource-kona-Print-warning-rather-than-panic
pull/spear-clocksource-init
review/ARM-DT-Add-missing-UARTs-for-bcm11351-bcm281xx
review/ARM-bcm281xx-Board-specific-reboot-code-v1
review/ARM-bcm281xx-Board-specific-reboot-code-v2
review/ARM-bcm281xx-Board-specific-reboot-code-v3
review/ARM-bcm281xx-GPIO-driver-v1
review/ARM-bcm281xx-TMON-driver-v1
review/ARM-bcm281xx-TMON-driver-v2
review/ARM-bcm281xx-adding-bcm28155-ap-dts-v1
review/ARM-bcm281xx-thermal-v1
review/ARM-bcm281xx-thermal-v2
review/ARM-bcm281xx-turn-on-l2-cache-v1
review/ARM-bcm281xx-turn-on-socket-network-support-v1
review/ARM-dts-bcm28155-ap-Fix-Card-Detection-GPIO
review/Add-Broadcom-Kona-I2C-Support-v1
review/Update-Kona-drivers-to-use-clocks-v1
review/Update-Kona-drivers-to-use-clocks-v2
review/arm-configs-bcm-remove-debug-ll-v1
review/bcm-bus-clk-v5
review/bcm-bus-clk-v6
review/bcm-smp-v4
review/bcm-smp-v5
review/bcm-smp-v6
review/bcm281xx-udc-v1
review/bcm281xx-udc-v3
review/bcm281xx-udc-v4
review/bcm281xx-udc-v5
review/bcm281xx-udc-v9
review/bcm2835
review/bcm59056-pmu-v1
review/bcm59056-pmu-v2
review/bcm59056-pmu-v3
review/bcm59056-pmu-v4
review/bcm59056-pmu-v5
review/bcm59056-reboot-fix
review/bcm590xx-add-addtl-regulators-v1
review/bcm590xx-add-addtl-regulators-v2
review/capri-boot-3.15-v1
review/capri-smp
review/clang-asm
review/do_syslog_tweak
review/dw8250_clock
review/dw8250_clock-v2
review/dw8250_clock-v3
review/enable-method-bindings-v3
review/enable-method-bindings-v4
review/gpio-centralize-locking-v1
review/gpio-fix-parameter-v1
review/gpio-get-v1
review/gpio-get-v2
review/gpio-irq-handler-v1
review/gpio-setup-message
review/gpio-unsigned-fix-v1
review/hawaii-v1
review/hawaii-v2
review/minor-printk-fixes
review/minor-printk-fixes-v2
review/mmc-card-event
review/mmc-for-tkryger-v2
review/mmc-for-tkryger-v3
review/mmc-for-tkryger-v4
review/mmc-sdhci-bcm-kona-fix-nonremovable-test-v1
review/mmc-sdhci-bcm-kona-linker-section-warning-v1
review/mmc-sdhci-bcm-kona-make-warning-go-away-v1
review/more-printk-flags
review/more-printk-flags-v2
review/printk-flags-v6
review/printk-flags-v7
review/sdhci-cd
review/sdhci-cd-v2
review/sdhci-cd-v3
review/serial-8250_dw-Improve-unwritable-LCR-workaround-v2
review/watchdog-v1
rfc/watchdog-resolution
wip/bcm59056-pmu-v3
Broadcom Landing Team Kernel
about
summary
refs
log
tree
commit
diff
log msg
author
committer
range
path:
root
/
drivers
/
usb
/
serial
/
pl2303.c
Age
Commit message (
Expand
)
Author
2013-08-12
usb: pl2303: fix+improve the divsor based baud rate encoding method
Frank Schäfer
2013-07-31
USB: pl2303: restrict the divisor based baud rate encoding method to the "HX"...
Frank Schäfer
2013-07-29
USB: serial: pl2303: fix the upper baud rate limit check for type_0/1 chips
Frank Schäfer
2013-07-23
USB: pl2303: remove debugging noise
Johan Hovold
2013-07-23
USB: pl2303: clean up set_termios
Johan Hovold
2013-07-23
USB: pl2303: clean up baud-rate handling
Johan Hovold
2013-07-23
USB: pl2303: refactor baud-rate handling
Johan Hovold
2013-07-23
USB: serial: set drain delay at port probe
Johan Hovold
2013-06-17
USB: serial: make minor allocation dynamic
Greg Kroah-Hartman
2013-06-17
Merge 3.10-rc6 into usb-next
Greg Kroah-Hartman
2013-06-10
USB: serial: ports: add minor and port number
Greg Kroah-Hartman
2013-06-10
USB: pl2303: fix device initialisation at open
Johan Hovold
2013-06-03
USB: serial: pl2303 works at 500kbps
Luca Olivetti
2013-05-30
usb: serial: dump small buffers with help of %*ph
Andy Shevchenko
2013-03-25
USB: pl2303: remove disconnect test from tiocmset
Johan Hovold
2013-03-25
USB: pl2303: fix return value of tiocmset
Johan Hovold
2013-03-25
USB: pl2303: fix TIOCMIWAIT and disconnect
Johan Hovold
2013-03-25
USB: pl2303: add custom tiocmiwait operation
Johan Hovold
2013-03-25
USB: pl2303: make set_control_lines a port operation
Johan Hovold
2013-03-25
USB: pl2303: use interface device for debug
Johan Hovold
2013-03-21
USB: pl2303: fix use-after-free in TIOCMIWAIT
Johan Hovold
2013-01-15
TTY: switch tty_flip_buffer_push
Jiri Slaby
2013-01-15
TTY: switch tty_insert_flip_char
Jiri Slaby
2013-01-15
TTY: convert more flipping functions
Jiri Slaby
2012-10-16
USB: pl2303: fix port-data memory leak
Johan Hovold
2012-10-01
Merge tag 'usb-3.6' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/usb
Linus Torvalds
2012-09-18
USB: Serial: pl2303.c: remove debug module parameter
Greg Kroah-Hartman
2012-09-18
USB: serial: remove debug parameter from usb_serial_debug_data()
Greg Kroah-Hartman
2012-07-16
tty: move the termios object into the tty
Alan Cox
2012-05-08
USB: serial: rework usb_serial_register/deregister_drivers()
Greg Kroah-Hartman
2012-05-07
USB: serial: remove usb_serial_disconnect call in all drivers
Greg Kroah-Hartman
2012-05-07
USB: serial: remove usb_serial_probe call in all drivers
Greg Kroah-Hartman
2012-05-07
usb-serial: clean up unneeded PM-related fields
Alan Stern
2012-05-03
USB: serial: pl2303: convert dbg() calls to dev_dbg()
Greg Kroah-Hartman
2012-04-25
USB: pl2303: remove unused define
Johan Hovold
2012-04-25
USB: pl2303: fix abuse of interface data
Johan Hovold
2012-04-09
USB: pl2303: fix DTR/RTS being raised on baud rate change
Johan Hovold
2012-02-28
USB: create module_usb_serial_driver macro
Greg KH
2012-02-24
usb-serial: use new registration API in [n-p]* drivers
Alan Stern
2012-01-13
module_param: make bool parameters really bool (drivers & misc)
Rusty Russell
2011-11-26
Merge 3.2-rc3 into usb-linus
Greg Kroah-Hartman
2011-11-15
USB: pl2303: use usb_serial_generic_open
Johan Hovold
2011-11-15
USB: pl2302: clean up error handling in open
Johan Hovold
2011-11-15
USB: pl2303: return errors from usb_submit_urb in open
Johan Hovold
2011-11-15
USB: serial: pl2303: rm duplicate id
wangyanqing
2011-09-26
USB: pl2303: add id for SMART device
Eric Benoit
2011-08-26
USB: pl2303: remove unreachable code
Michał Sroczyński
2011-07-19
USB: serial: add IDs for WinChipHead USB->RS232 adapter
Wolfgang Denk
2011-07-08
USB: PL2303: correctly handle baudrates above 115200
Michał Sroczyński
2011-02-17
tty: remove filp from the USB tty ioctls
Alan Cox
[prev]
[next]